LEPA to Release MX-F1 and MaxGold 1000 PSUs

LEPA is ready to release a new series of entry-level power supply units entitled MX-F1. The series counts three models of 400 W, 500 W and 600 W capacity: N400-SA-EU, N500-SA-EU and N600-SA. In addition, the company has expanded its MaxGold line with a flagship 1000-watt model. It corresponds to Intel ATX12V 2.4 standard and employs an optimized hardware design.

To begin with, MX-F1 PSUs offer 87% of ultimate efficiency. Operating at 20%/50%/100% loading, they are able to achieve 82%/85%/82% efficiency correspondingly. Nonetheless, the models cannot receive 80Plus Bronze certificate, since they feature limited voltage input range. All the models within the series employ a single +12V rail and boast a non-modular design.

This promotes for the connection of middle-efficiency components. They support Active PFC and a wide spectrum of protective functions (over-voltage, over-current, over-power, short-circuit). Cooling of internal components is ensured by a single 120 mm fan. …

Meet Strike-X Air and Vx Advance Series from Aerocool

Devotees of a futuristic design and uncommon framework cannot but revel in the launch of new chassis Strike-X Air from Aerocool developers. The long-awaited product is already in the market, as well as new Vx Advance series. Chassis Strike-X Air is distinguished by the ultra-original design and open-end framework type. According to the words of Aerocool representatives, the major emphasis has been made on the handiness of usage so that each person could have a direct access to any component of the chassis.

The chassis of Strike-X Air is made of steel and supports motherboards of Micro ATX, E-ATX and ATX dimension type, and graphics cards of 330 mm. length. Expansion cards and interface panels are installed due to the ten slots in the rear part of the device. The chassis is equipped with three external modules of 5.25 and 3.5 inches type. The clipboard is intended for a single USB 3.0 socket, three USB 2.0 sockets, and a couple of 3.5 mm. sockets for headsets with a microphone. … …

MSI is preparing new model - Radeon HD 7970 with a water-block

The well-known in IT-maker Company MSI announced about appearance of new videoadapter based on GPU Tahiti XT chipset. Its diversity from the other Radeon HD 7970 can be seen with the naked eye, instead of an air cooler practically the entire surface of the PCB is covered with waterblock brand EK. It differs markedly from the original version, since it is designed specifically for the MSI R7970 Lightning model. Relation of adapter to the Lightning series is easily determined by the inscription at the interface connector PCI-E 3.0 x16, as well as non-standard set of video outputs (2x DVI, 4x Mini DisplayPort) and configuration of additional power connectors (2x PCI-E Power 8-pin).

Obviously, the accelerator is positioned as the Radeon HD 7970 GHz Edition and has a nominal frequency of at least 1050 MHz. Will MSI risk, like Sapphire did, and provide the card with 6 GB of memory? Probably not. The «advanced» composition of the printed circuit board and water block of full coverage …
Get computer-assisted driver search with our brand utility *
* The Utility requires installation. Upon installation and running DevID Agent will detect
which devices require drivers and which drivers require updates.
The Utility doesn't contain viruses or malicious code
Registered at: 08 May 2011, 16:55
Last visit: 08 May 2011, 18:56